Scott Kelsey
Super OPE Member
- Local time
- 11:19 PM
- User ID
- 6375
- Joined
- Jun 10, 2018
- Messages
- 271
- Reaction score
- 316
- Location
- Wisconsin
As the title states I am searching for a decompression valve for a McCulloch 797. New or used is fine.
WANTED McCulloch 797 decompression valve
- Thread starter Scott Kelsey
- Start date
dolmarkid
Pinnacle OPE Member
- Local time
- 11:19 PM
- User ID
- 428
- Joined
- Jan 6, 2016
- Messages
- 1,058
- Reaction score
- 2,182
- Location
- Belleville IL
i would try rich dougan at myrtle creek saw shop in oregon
Scott Kelsey
Super OPE Member
- Local time
- 11:19 PM
- User ID
- 6375
- Joined
- Jun 10, 2018
- Messages
- 271
- Reaction score
- 316
- Location
- Wisconsin
The saw I picked up is missing it.
Last edited:
Altamaha
Super OPE Member
- Local time
- 9:19 PM
- User ID
- 8541
- Joined
- Jan 26, 2019
- Messages
- 120
- Reaction score
- 458
- Location
- Port Angeles, WA
I know it is a 2 year old post but I just installed one in my 795L.
The Decomp valve was missing and replaced by a bolt screwed into the port. I could not start the saw in this configuration, too much for this 73 year old guy.
I finally found one (both the valve and the seat) on Ebay 3 weeks ago and installed it. I will give it a test start tomorrow.
Why in the world would someone remove the Decomp valve?
Same powerhead on my 895 Mac, it is a dream to start when using the Decomp valve.
The 795L:
Look close, you can barely see the threaded insert seat. I had to drill & tap the cylinder for the seat, then index the seat & drill a port to line up with the discharge port from cylinder to exhaust. Yea, it is dirty, I will clean up the carbon when I paint the saw this winter.
The Decomp valve was missing and replaced by a bolt screwed into the port. I could not start the saw in this configuration, too much for this 73 year old guy.
I finally found one (both the valve and the seat) on Ebay 3 weeks ago and installed it. I will give it a test start tomorrow.
Why in the world would someone remove the Decomp valve?
Same powerhead on my 895 Mac, it is a dream to start when using the Decomp valve.
The 795L:
Look close, you can barely see the threaded insert seat. I had to drill & tap the cylinder for the seat, then index the seat & drill a port to line up with the discharge port from cylinder to exhaust. Yea, it is dirty, I will clean up the carbon when I paint the saw this winter.
Last edited:
