mowerguy88
OPE Member
ive got a zero turn with a kohler command ch23s 76586. it ran great all summer. this fall after i mowed for the last time it sat for about 2 weeks and i went to start it so i could service it and get it all ready for next season before i put it away for the winter. well i started it up and it didnt seem to run quite rite so i held my digital tach to both wires and they were both giving me an rpm reading so i know both coils are sending spark. i then misted the muffler right where it comes out of the heads and discovered it wasnt running on the right cylinder. pulled the spark plugs and they were both fouled pretty good so i replaced them and retested. same thing only running on one cylinder. i did a compression test and both cylinders have exactly 190 psi i put a spark checker on the bad cylinder and it has a strong blues spark and it will jump a 6mm gap no problem. i used my inductance spark checker on it and its giving me a high voltage alert on both cylinders which is strange to me. it has vaccum in the crank case while running i havent done a leak down test yet as i have to pull the engine to be able to remove the shroud. does anyone have any thoughts on what it could be before i yank the engine? i dont think its blown head gaskets due to the compression readings. oh ive also removed both valve covers and the valves are operating like they should be on both sides. im thinking its either a bad ignition coil or a compression issue since its so high. i thought these had an auto compression release mechanism if so it must not be working since its got that amount of compression with just the started cranking it. let me know your thoughts please
