SELLING Jonsered 2150 w/ 20 b&c

[Sawdust Man]

Selling this average Johnny 2150

I bought it off of @Johnmn here on ope a couple years back, and have not ran more than a half dozen tanks through it since.
It's got a dual port muffler, base gasket delete and a timing advance, and it runs runs pretty mean.
All the mods were done by the fine member I bought it from, I haven't wrenched on it at all.
It's got a 20" .325 bar with pretty much new oregon full chisel chain.
$240 with the bar & chain, or $200 pho, plus shipping.

 

[Sawdust Man]

 

[Sawdust Man]

 

[ammoaddict]

Is that the same as a Husqvarna 350?

 

[timg]

Decent deal on a NLA Lost Redhead. Great looking piston too!

 

[Woodslasher]

@davidwyby

 

[Nate.]

Is that a 346 top end? Maybe I’m missing em but it doesn’t look like it’s got the removable transfer covers.

 

[Woodslasher]

Is that a 346 top end? Maybe I’m missing em but it doesn’t look like it’s got the removable transfer covers.

Not all 350's had them if I recall right, just later ones.

 

[Nate.]

Is definitely possible! I’ve never seen one without the removable covers.

 

[Woodslasher]

I think it was @huskihl who told me that some 350's didn't have them, but I could be wrong.

 

[jacob j.]

I think it was @huskihl who told me that some 350's didn't have them, but I could be wrong.

Early 350s had an open-transfer cylinder (44mm I think) without the covers. I think the early 2150s had them too. That's what this one looks like.

 

[Nate.]

after doing some digging it looks like the early 350’s with open transfers had them. The later cylinders had the removable covers. I’ve worked on 8-9 350’s for people & never seen one before .