SOLD Husqvarna 345

[Fruecrue]

Selling as a parts saw because of a few issues, but does run and cut.

The bad;
Plastic intake boot clamp
AM operator presence lever
Both muffler bolt threads have been repaired, muffler does mount up good and solid.
Needs a carb kit. Was stored dry for a while, I pulled it out and fired it up yesterday, didn’t tune right. After sitting overnight with fuel in the carb, much better today but still a little slow to rev up and has some run on before returning to idle.

The good;
Piston and cylinder look good
Runs, idles, cuts.
Has good torque for a little guy.
I’ve heard these can be converted to 346 status.

Asking $100 PHO.
$125 with bar and chain.
You pay shipping.

 

[usmcbuckwild]

$100 bucks is a good deal for a running little saw.

Yes, these are easily converted over to 346 or 353 with proper parts. Makes for a very light little limber with great power.

 

[Fruecrue]

Thanks Buck.

 

[Fruecrue]

I like trades too.
Open to offers.
I need a Dolmar 7900 muffler, Always open to 1122 and 1128 parts.

 

[Fruecrue]

I even included air filter pics...


Bump.

 

[RIDE-RED 350r]

Why is this tempting me???

 

[RIDE-RED 350r]

Oh wait a sec, I know.... I happen to have a descent used 346OE cylinder sitting on a shelf with nothing to do...

 

[usmcbuckwild]

Oh wait a sec, I know.... I happen to have a descent used 346OE cylinder sitting on a shelf with nothing to do...

Buy it. You know you wanna do a build thread with it.......

 

[Dub11]

Oh wait a sec, I know.... I happen to have a descent used 346OE cylinder sitting on a shelf with nothing to do...

@Stump Shot has one........

 

[Stump Shot]

@Stump Shot has one........

I does.

 

[RI Chevy]

Bump

 

[Fruecrue]

Bump

 

[Stump Shot]

Great starting point for an inexpensive hot rod saw project here boys and girls.

 

[J. Dirt]

Hmmmmm 44mm piston? How’s the case in the front not all melted is it? I think the one picture it looked decent. Hard to tell.

 

[J. Dirt]

Oh wait a sec, I know.... I happen to have a descent used 346OE cylinder sitting on a shelf with nothing to do...

I could give it a new job send it this a way....

 

[Fruecrue]

Hmmmmm 44mm piston? How’s the case in the front not all melted is it? I think the one picture it looked decent. Hard to tell.

I can get more pics tomorrow. Didn’t notice any melting on the case.
Don’t know bore size, whatever a 345 is stock.

 

[tickbitintn]

If I didn't already have 4 tree fiddys I'd be on it like white on rice....
Makes a great sleeper.
I built the prius guy one a few years back and he only ran a couple tanks thru it and said it was cute.
He's happy with the tree 9 foe... hasn't touched any of his other saws since.
GLWS

 

[Fruecrue]

If I didn't already have 4 tree fiddys I'd be on it like white on rice....
Makes a great sleeper.
I built the prius guy one a few years back and he only ran a couple tanks thru it and said it was cute.
He's happy with the tree 9 foe... hasn't touched any of his other saws since.
GLWS

The Prius guy. Lol.
That runs a 394.