- Local time
- 10:47 AM
- User ID
- 441
- Joined
- Jan 8, 2016
- Messages
- 4,282
- Reaction score
- 10,906
- Location
- Farmington, CT
I've got about $1500 into this saw after months of building. Much of the build you can watch on youtube.
Cases, are powdered black by @Glock37 ... and the muffler / clutch cover was done by him as well.
New oem starter and tank dyed by me.
New KS head ported by Rattler
prosafety wrap from Rory (worth $200 by itself)
high top by me
New oem walbro carb ($130 if you can find them)
new oem blue ignition.
oem throttle lever was modified to allow for full wide open throttle
t540xp momentary off switch
theres only a few am parts on here, including clutch, starter pulley, nachi bearings, but the rest is oem including seals and gaskets.
well behaved saw, great power, oils nicely, oem brake stops fine
If anyone has a reasonable offer I'll entertain it... thanks!
Cases, are powdered black by @Glock37 ... and the muffler / clutch cover was done by him as well.
New oem starter and tank dyed by me.
New KS head ported by Rattler
prosafety wrap from Rory (worth $200 by itself)
high top by me
New oem walbro carb ($130 if you can find them)
new oem blue ignition.
oem throttle lever was modified to allow for full wide open throttle
t540xp momentary off switch
theres only a few am parts on here, including clutch, starter pulley, nachi bearings, but the rest is oem including seals and gaskets.
well behaved saw, great power, oils nicely, oem brake stops fine
If anyone has a reasonable offer I'll entertain it... thanks!
