SELLING Husky 365 stuffs

[Mkinslow]

Selling 365 stuffs, 2 tecomec pistons and one tecomec crank ,neither have ever been used. Crank has some light rust on flywheel thread side and on clutch side, very little should clean up just fine. one cylinder is OEM open port in great shape. Other cylinder is 365 x-torq, not too a shape, has a gouge dead center above exhaust port,plating looks fine, personally I'd run the crap out of it, but everyone is different.
$30 each for cylinders shipped
$10 each for pistons shipped
$45 for crank shipped
PayPal f&f or pay the fees

 

[Mkinslow]

.

 

[Mkinslow]

.

 

[Mkinslow]

Bump it back up top

 

[jloomis]

Would any of it work for a 372xp x-torq? I need crank piston and jug.

 

[Mkinslow]

Would any of it work for a 372xp x-torq? I need crank piston and jug.

I know the cylinder will work on the cases,but not 100 percent sure about the crank difference, if any. I'll see if we can get better clarification on this. @huskihl ,@cuinrearview ,@dustinwilt68,@ can yall shed some light on this question. I don't wanna tell the man wrong.

Sent from my SM-G892A using Tapatalk

 

[brad ruch]

Should be the same crank

Sent from my Pixel 2 XL using Tapatalk

 

[Mkinslow]

Should be the same crank

Sent from my Pixel 2 XL using Tapatalk

Thanks,I can't remember the exact differences between the two, but if I'm not mistaken there's not many

Sent from my SM-G892A using Tapatalk

 

[dustinwilt68]

You would need to swap the transfer covers on the.365 cylinder to make it equal a 372 xtorq, all bolts right on. Takes a T20 security bit.

 

[Mkinslow]

Ok,so it looks like everything should swap over to the 372xtorq cases.

 

[Mkinslow]

Bump