Treewolf
New OPE Member
Does anybody have a workshop manual for an Echo CS-362? Been searching all over and can't find one.
As a side, been running this saw for about a week and am very impressed with it. Not quite on par with my MS200t but I am sure it will loosen up after a few tanks have been through it. Would happily recommend this saw, especially based on the fact it was almost 50% of the cost of an MS201.
As a side, been running this saw for about a week and am very impressed with it. Not quite on par with my MS200t but I am sure it will loosen up after a few tanks have been through it. Would happily recommend this saw, especially based on the fact it was almost 50% of the cost of an MS201.