WANTED Craftsman 3.3 / Poulan Recoil Parts

[Gvsu141]

Looking for recoil parts for a Craftsman 3.3 I picked up. I know several Poulan saws share the same part. Recoil spring works well, I need the plastic pulley. Poulan 3300, PP335, and several others. The pulley part number is 530027170, and there are a few others part of the same assembly.

Looks like the official parts list is:
530027170 - Pulley
530027162 - Starter Dog
530027163 - Retainer

 

[Gullet]

Big fan of that saw.
I have 2- 3.3's & a Poulan 3300.

They made 2 types of starters.
One on left like yours with the single dog & one on right with dual dogs.
I much prefer the dual dog design.
Same part# on both flywheels so I'm not sure why the dual type wouldn't work.

I just bought a 4 pack of starter dogs from Randy's Engine Repair for $14.
Might look @ their website or give em a call.

 

[Gullet]

EDIT:
Scratch that, the dual dog pulley is bigger & won't work.
Guess I should have mic'd em FIRST! Lol

 

[Gvsu141]

Big fan of that saw.
I have 2- 3.3's & a Poulan 3300.

They made 2 types of starters.
One on left like yours with the single dog & one on right with dual dogs.
I much prefer the dual dog design.
Same part# on both flywheels so I'm not sure why the dual type wouldn't work.

I just bought a 4 pack of starter dogs from Randy's Engine Repair for $14.
Might look @ their website or give em a call.

Thanks.

Are those covers the same thickness? I was told the dual dog design used a slightly thicker starter cover design, but with the same flywheel.

 

[Gvsu141]

EDIT:
Scratch that, the dual dog pulley is bigger & won't work.
Guess I should have mic'd em FIRST! Lol

Darn, it would be nice!

 

[Gvsu141]

Just popped the muffler off, piston looks great. Should be a good runner once I find a recoil.

 

[Gullet]

Its about 1mm thicker (can't even tell by looking).
Dual dog design pulley is also a little taller, thus goes deeper into the flywheel I assume.

 

[Gvsu141]

Its about 1mm thicker (can't even tell by looking).
Dual dog design pulley is also a little taller, thus goes deeper into the flywheel I assume.

I wonder if there would be a way to modify/trim it to fit...