390xp cylinder hunt

[thomas m chiconas]

Looking for a husqvarna 390xp cylinder to buy. . Used preferred.

 

[Woodwackr]

Looking for a husqvarna 390xp cylinder to buy. . Used preferred.

Good luck. I gave up and ordered Duke's kit. $300+ for oe vs $65 for their hard chrome. Worked great, only minor cleanup to both piston and cyl.

 

[MG2186]

Good luck. I gave up and ordered Duke's kit. $300+ for oe vs $65 for their hard chrome. Worked great, only minor cleanup to both piston and cyl.

I got one I’d trade for a 54mm kit if you’d happen to have one of those

 

[Stump Shot]

Looking for a husqvarna 390xp cylinder to buy. . Used preferred.

Pretty sure there's one out in my cylinder stash. I'll check tomorrow and report back.

 

[Woodwackr]

Pretty sure there's one out in my cylinder stash. I'll check tomorrow and report back.

So, where were you when I needed one?
I'm hurt...

 

[Stump Shot]

So, where were you when I needed one?
I'm hurt...

I dunno, I don't recall seeing that, sorry if I missed it.
Might have two, but I can't be sure until I check here in a little bit.

 

[Stump Shot]

Well, I searched and came up with two take offs, one has minimal transfer on the exhaust side spread out evenly, the other has what looks like part of a wrist pin keeper just under the transfer part about 1/8" to 3/16" long.
If either @thomas m chiconas and/or @Woodwackr are interested please let me know and i will clean one up for you, @thomas m chiconas has first pick.
I did not have any 54mm versions @MG2186 only the two 55mm stated above.

 

[Woodwackr]

I dunno, I don't recall seeing that, sorry if I missed it.
Might have two, but I can't be sure until I check here in a little bit.

I tried one of Dukes hard chrome kits, came out just fine.
Saw belongs to a friend’s son who ran over it.

 

[thomas m chiconas]

Thank you

Well, I searched and came up with two take offs, one has minimal transfer on the exhaust side spread out evenly, the other has what looks like part of a wrist pin keeper just under the transfer part about 1/8" to 3/16" long.
If either @thomas m chiconas and/or @Woodwackr are interested please let me know and i will clean one up for you, @thomas m chiconas has first pick.
I did not have any 54mm versions @MG2186 only the two 55mm stated above.

tom here. I am interested in one of them for sure. Thanks

 

[Stump Shot]

Thank you

tom here. I am interested in one of them for sure. Thanks

I will clean one up for you and report back if I can get a good one of the two.

 

[thomas m chiconas]

I will clean one up for you and report back if I can get a good one of the two.

Thanks!