SOLD 25" Stihl Rollomatic ES Bar 3/8 .050 84DL, 4 times

[maulhead]

Four Stihl Rollomatic ES Bar's for sale.

The lower 3 are part # 3003 000 8830 and the top 1 is part # 3003 000 4030

All four are same specs, 3/8 .050 84DL. I'm not sure why one has a different number. All four say made in Germany on them.

These bars were used on 044's as limbing saws, so the paint is worn off the tips. Main parts of the bar still have most of their paint. A few of them have a slight edge on them and could stand to be dressed.

$55 each bar shipped in the lower 48 states. If someone wanted to buy all four of them, package deal, I would do $195 for all four shipped.

 

[maulhead]

Other side....

 

[maulhead]

Number on the top one,





Bottom 3 all have this number,

 

[Flying_Dutchman]

The top one has a different tip.

Sent from my moto g(7) power using Tapatalk

 

[maulhead]

The top one has a different tip.

Sent from my moto g(7) power using Tapatalk

I noticed that after posting, and staring at the one pic for a few minutes.

 

[stihl livin]

Top bar has a green dot on the tail the rest have yellow dots.

 

[maulhead]

Top bar has a green dot on the tail the rest have yellow dots.

Any pic's of your tail?

Asking for @Woodpecker

 

[Big_6]

What does TJ and TL mean after the model number?
Just the tip? Is it a 10-13 tooth difference?
Who wins after gearing up for cookie cutting?


Sent from my SM-N975U using Tapatalk

 

[maulhead]

What does TJ and TL mean after the model number?
Just the tip? Is it a 10-13 tooth difference?
Who wins after gearing up for cookie cutting?


Sent from my SM-N975U using Tapatalk

I have no idea what the TJ and TL mean after the model number, I looked them over tonight, one of them has a TM on it after the part number. Must be some kind of code at the factory, just a guess on my part.

 

[maulhead]

Figured I'd update this thread.

The two bars in the middle, I put the red stars on are sold.

Other two are still up for sale, $55 each, or $100 for both, shipped in the lower 48 states.

Minimum bar depth groove on 3/8's bars is 6mm, new ones are 8mm deep.

Both of the bars left, measure 7mm to 7.5mm deep, still very close to 8mm deep.

Still tons of life in these bars, anyone want them?

 

[Logging]

still available? sweet deal

 

[maulhead]

still available? sweet deal

Bottom 3 are sold, top 1 is still for sale. Let me know if you want it.

I think I have one more also, I just have not checked it out yet.