FOUND IT 066 plastic cylinder cover badge (used)

[jk14]

Looking for a used not so pretty (to match my saw) 066 cylinder cover plastic badge. Not looking for new, as I know they are available but the rest of the saw on the ugly side.

 

[jmester]

Does it matter if it is for a 660

 

[jk14]

Does it matter if it is for a 660

660 is better than nothing. Let me know. Thanks.

 

[jmester]

let me do some digging I may be able to come up with the right one. That is what I had in my drawer. Will get back with you.

 

[jmester]

Let me know if that one suits you.

 

[Tractorsaw1]

What's good to keep them from falling off?

 

[jmester]

They have two pegs that stick down and snap in to the cylinder cover. You could glue it in( hot glue might work)or find a good used one. Or a new one. Don't think they are very expensive

 

[Canadian farm boy]

Whenever I replace the ID badges I always put a couple small blobs of silicone on the bottom of the new badge. Be careful not to put to much on or else it will squish out around the badge when you install it.

 

[Tractorsaw1]

Ok - last 1 I did ended up out in the woods somewhere- picked up the saw & noticed it was gone. I picked up another but would like to keep it