ZeroJunk's latest activity
-
ZZeroJunk replied to the thread 036 hard to pull starter cord.Well, the 1300 is a "dumb" coil with no advance. Seems to have ignored my post about dry cylinders being difficult to pull. I start...
-
ZZeroJunk replied to the thread 036 hard to pull starter cord.I start so many different saws a week I won't even put a number on it because you would just think I am lying anyway. But, several...
-
ZI just talked to a guy in the UK who was a famous phone sex extraordinaire and he said the US delivered 400s won't smell like fish and...
-
ZDisassembly in high gear on the '72 Javelin 24 Hours of Lemons race car project.
-
ZZeroJunk replied to the thread Crank bearing installation question.Stihl concrete or cut off saws like a TS-420 have some type of rubber/ neoprene or whatever flat seals that fit in two grooves in the...
-
ZProbably quicker to run the oil feed line to the carb and the fuel line to the oiler than it is to explain what the issue was. That way...
-
ZZeroJunk replied to the thread What oil is best? and what ratio?.Had a MS170 Friday that had the fuel tank full of bar oil and bar oil tank full of fuel. Don't see why they can't make them run either way.
-
ZI sometimes get confused about which is the 40 and which is the 1 when I mix too...
-
ZZeroJunk replied to the thread What oil is best? and what ratio?.wow
-
ZThere were never any issues with any 2 stroke oil or whatever oil in place of bar & chain oil until the internet came along.
-
ZOn a young girl always very good 🤠😎👍
-
ZZeroJunk reacted to Squareground3691's post in the thread What oil is best? and what ratio? with
Like.
Coconut 🥥, -
Zsun oil throug a bikini good?
-
ZBill turned his dishwasher into a snowblower one Too many times
-
ZZeroJunk replied to the thread What oil is best? and what ratio?.I was talking about using used burnt motor oil for bar oil 50 years ago, little longer ago than that actually. Not sure how it morphed...