ZERO's latest activity
-
^^^^^^^This 100%. Welding onto them gives a heat shock that breaks the corrosion and rust loose. -
ZERO reacted to singinwoodwackr's post in the thread Looking for ideas on broken stud removal with
Like.
I’ve had good luck with making a good center point with a good center punch and/or a small burr. Then, carefully drill out the center... -
I'd weld a flat washer to it then a nut and I bet it will spin right out
-
I have had some success using a small end mill to create a flat surface, then drilling the broken bolt/stud enough to get and easy out...
-
Jim, My suggestion is drill out to maximum size without disturbing threads. Very small lengthwise ball burr straight line of remaining...
-
What you are looking at is an exhaust stud broken off below the surface in an otherwise serviceable 66mm 090 cylinder. How would you...
-
That was me. If the foggy sail repair does not work this usually does unless the coil is bad which is pretty rare only had it happen to...
-
Yes, that is what I think he is referring to and the chip used with this mod.
-
Any chance that this is the photo in question? red/orange silicone on the ignition plate, after the repair...
-
Is there supposed to be a picture attached?
-
I think the red silicone (permatex) is there just to protect the solder joints from corroding down the road.
-
Can you guys tell me what chip to get and the wiring.I am guessing one of the chip wire goes to the little wire come out of the coil...
-
ZERO reacted to Duane(Pa)'s post in the thread Are 1/4 pitch 0.050 chains like 13RMS and H00 compatible with 71PM3 type spur sprockets? with Like.
IDK if the sprocket fits other things besides a battery saw. My HT56 pole saw came with 1/4 .050 I don't recall how it looks on the...
-
ZERO reacted to Sloughfoot's post in the thread Are 1/4 pitch 0.050 chains like 13RMS and H00 compatible with 71PM3 type spur sprockets? with Like.
Mark, do you know if the .050 3/8 picco super chassis is the same as the chassis on a .050 3/8 picco micro?
-
ZERO reacted to heimannm's post in the thread Are 1/4 pitch 0.050 chains like 13RMS and H00 compatible with 71PM3 type spur sprockets? with Like.
Although the pitch is the same, the chassis height is different and will require a different sprocket to fit each chain correctly, much...