ZERO's latest activity
-
ZERO reacted to Lawless's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with
Like.
First time using one of the chains I ground was today. Performed just like a new one and I am very happy with it. It was a .325 - 0.050... -
One ring end gap .014, other is .018. Side clearance (between the ring land and the ring) is .004". Apparently this saw had quite a few...
-
I haven’t had a chance to get back at it. Hopefully that will change in the next month.
-
How's this saw going Greg? Had a chance to get back to this one?
-
I already got vouched for and approved.
-
I believe it's @theduke1971 per the first two posts.
-
There are a lot of dudes named Troy on this forum. What's this Troy's username on here? I'll check his selling permissions.
-
and that's when you DM me. (Mostly available Tue and Thu with some variance.)
-
346 oe going back together
-
DITTO and DOUBLE DITTO. Next week I will be asking advice for this same thing but for myself who knows.
-
It think this is just a way to isolate the cylinder side from the carb side. The rubber is tough, but will give way to the scrench if...
-
I had to look it up and evidently it's a low emissions engine .That I once worked on an early 441 that also blew out plugs .If I recall...
-
The Helicoil Sav-A-Thread kit is M14x1.25 Mark
-
I love helicoils. I’ve done several saw spark plug holes and quite a few aircraft repairs involving their use. Every single threaded...
-
I can think of two other causes. I've seen lots of cross threaded plugs in aluminum heads strip the threads. Also seen plugs left in...