ZERO's latest activity
-
The cylinder and roof are perfectly fine. Other than the plating getting thin beside the port where the loose piece of aluminum was... -
Also inspect the exhaust port roof for any damage.
-
I’ll measure the gap later this week.
-
Scoring often doesn't accompany this situation. And it can go along time before manifesting itself. All it takes is a heat excursion...
-
There is no scoring, which should happen during a case of the ring being tight. Also, a tight ring gap would show up before a year of...
-
I've seen some Echo blowers pb-403 pb-413 and pb-620's , that the exhaust port was nearly flat on top. High hour landscaper units...
-
I must agree with everyone so far the 572 & 565 are both great saws. They run extremely well stock & with a heavy muffler porting and...
-
If you’re talking about the red plastic caps, I pull them with a drywall screw, trim the tab off and put them back in. I’ve had a few...
-
The needles stay in place just fine with them off, but due to how small the needles are it can be hard to line up a flat screwdriver...
-
OOOh! Today I pulled 4 off two 2511T carbs and tossed them in the trash. Guess I'll be dumpster diving in the morning.
-
I follow an Echo guru on yt. He puts them back on after defeating them. His reason is easier to get tuning screwdriver alignment with...
-
I own and use Echo saws almost exclusively now, and I agree 100% with the advice and reasoning that Jmester offered.
-
Not really familiar with echo limiter caps. But on other manufacturers I usually just trim off the portion that limits the adjustment...
-
When you folks remove the carb limiters on an Echo chainsaw, do you throw them away or reinstall? Do the limiters serve any purpose to...
-
ZERO reacted to tree monkey's post in the thread 661 muffler mod progression w/thermocouple with
Like.
yes