ZERO's latest activity
-
The tensioner isn't doing anything after you tighten the bar nuts. Forget about that. You have a wierdly stretched chain, Which I... -
Observe the protrusion of the nose sprocket teeth as you rotate it. This is dragging on like it's winter or something! lol
-
So it’s down to, Oregon versa lightweight bar or the tensioner. The 28” added too many variables, so I’m wondering if I add the OEM 325...
-
And the crank is not changing position while you're advancing the chain by hand. The clutch drum should be spinning freely while the...
-
The crank did not get bent and then unbend itself and then bent again. So don't worry about that.
-
I’m thinking I will mount up the original 325 OEM sprocket, bar and chain. If it does it there I will know it’s internal. Tensioner...
-
-
Well, the plot has thickened. Got bored between periods of USA hockey. Mounted up a used chain on the Oregon bar again. The situation...
-
Possibly check the drive links I’ve seen where they kick off the bar and become mushroomed in sections and they bind as they’re coming...
-
Went back to messing around this morning, took the whole drum and rim assembly off, put it back on. I think it was some casting...
-
. Ya I asked that few days ago….?!?
-
Replace chain as has even mentioned. This will eliminate that variable.
-
I guess you could hold up on tightish chain and slowly pull the start rope and see if chain gets loose? Wobble wobble
-
They are good and easy to deal with!
-
I bought a bar and a saw from them two different purchases separated by a couple years. Shipped the same day and I received them the...
