ZERO's latest activity
-
How much was the postage? How much was the tax/duty? -
If your weather is heading the same direction ours is it will not be long before you can use the 2 jugs of Glyphosate that the saw is...
-
I have run it in br800x and fs131r. Clean and responsive at 50:1. Runs a tad warmer than Saber but has a better hit. Edit... Smells good.
-
Could be, if this problem is only during operation. My impression was that the chain gets loose and tight while spinning it by hand.
-
Bent crankshaft…
-
My last one was a Chinese rim. It was very loose fitting on the clutch drum, not obviously out of round persay, but it moved alot...
-
I will look into that tomorrow. I cut a few logs down to firewood size this afternoon. Will go retension and check those components
-
I would check the tensioner and associated parts just to have one more thing ruled out. I find it hard to believe the links would be...
-
Bar, chain, sprocket and rim are new.
-
Is this a new sprocket or used? Is the bar tip new or used? If used, have you checked all its teeth? And if replacable-tip used, is it...
-
Maybe where the drive teethes sit in is crooked. You cant measure from the outside. One tooth sit higher than the others would cause this.
-
My understanding is that Husqvarna and Stihl are both doing it for weight savings. It seems to me that there is somewhere better to cut...
-
Same reason you have torque to yield in your car. Just replace with steel. The couple of grams aren't going to matter.
-
Well ! I ran my 500i yesterday after a fresh build and I am really suprised. Was cleaning it up today and for some stupid thought I...
-
I had fun making a dodecagon post (12 sided) out of white oak. This picture was partway through the process. Getting there slowly...
