ZERO's latest activity
-
Is probably a combination of the extreme cold, design and material, which makes it weak. What might be interesting to know is whether... -
Back to random thoughts. Fun fact: An oem 500i piston kit costs as much as a FORGED 550 Suzuki piston kit for my Bearcat Widetrack wood...
-
When a short run in the usc doesn't work often a day or two submerged in a jar of gasoline can soften up a clog.
-
I just got done double checking and verify a few things. The carb holds 7 psi of pressure and vacuum. The purge bulb is hooked up and...
-
Yes. If the check valve is bad, air will pull back through and into the metering chamber.
-
Could be the purge bulb. Can you feel suction on one side and pressure on the other side?
-
Woops, wrong thread. 😐
-
Report back after the pressure/vac test, as the only solenoid looking deal that I ever had to replace, was one someone tried to pry off...
-
Yes, I verified the purge bulb is hooked up correctly and I installed a new OEM fuel filter. Thanks for the ideas, Keven. Yes, a fuel...
-
Pull your fuel line out of your tank and plug your vacuum tester straight in the line. Put 5pd or so of pressure and see if it holds if...
-
The inlet screen should be thoroughly checked as a fuel blocking light film can be present that looks near invisible until it's removed...
-
I’d be more concerned about a vacuum test. Plug the inlet and make sure the purge side holds a vacuum, which will tell you if the check...
-
Fuel supply issue. Carb rebuilds are easy. I’m sure you did that right, although it’s always important to pressure test it after the...
-
Danzco will be the quickest option https://www.6kproducts.com/sprocket-325_pitch.html
-
This is not particularly helpful, but looking in my sprocket bins I find .325-7 in Stihl Mini, .325-7 in small spline (Archer), .325-8...
