ZERO's latest activity
-
Ok here’s the long explanation: I could not recommend any epoxy, as plastic fuel tanks and cans are a type of plastic that is... -
Thank You I didn't (Should Have) read the can Label. I was going to check NAPA for a good epoxy. Any ideas from the expert?
-
Red Kote specifically says not for plastic tanks. I use some UHMW PE plugs on tanks from time to time and the Red Kote peals off of...
-
I agree. I was looking on the net about Red Kote and so many places said metal tanks - rust - pinholes . Nobody suggested plastic. My...
-
I don’t think so. There are better ways to fix plastic tanks.
-
Don’t know. If you have some sitting around test it out on the outside, really nothing to loose?!?
-
Will RED KOTE adhere to plastic? I never thought of using it. If so do you think it would stick to the inside as a small patch area...
-
Any epoxy that is fuel safe, but a tank sealer epoxy is best...the kind you put in a tank that has a leak/hole and roll the tank around...
-
Using the Super Glue will seal the tank crack and protect the epoxy from the tank side of crack. Do you or anyone have an epoxy...
-
This thread has a lot of great Ideas/procedures to choose and or combine when a tank needs repaired. I have 2 Jonsered tanks needing...
-
I’d superglue. Then roughly scuff the outside. Use any good plastic friendly epoxy in a thin layer, and fiberglass cloth. Several...
-
Sounds like impacted sawdust/debris has built up around underneath the rim of the drum and is causing issues. I tap the drum back down...
-
ZERO reacted to singinwoodwackr's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
Pics…. -
You’re saying the tang is coming out of the groove?
-
ZERO reacted to helislacker's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Hello all. New to the forum so excuse me if this doesn't belong here. I have an 440 that I've been running for years now. Just...