ZERO's latest activity
-
limb removal -
I went out and rode around the mountains
-
I am cooking a Hedge post..............
-
Played with the new $74 shoebox size, amazon flux core welder. Very surprised at what it could do without any wire speed control...
-
Installed the extended wear kit on my winter work gloves ….. Stuck a good sharp skip chain on the 066 ….. I hauled a few large...
-
Been great, probably my all time favorite. Muffler did start cracking from the corner of my muffler mod after I tried welding deflector...
-
Lower # than Huskys Oldest listed SKU. Willie Wonka said something like "Strike That -- Reverse it"
-
Mines an early first year production without the added webbing on the bar mount. That’s not been an issue but I don’t use it as a pry...
-
No case replacement. Maybe I should have said fairly early, instead of one of the first. It's SKU number 970493100 and Husqvarna lists...
-
You're old. Lol
-
I thought the case reinforcement was added after the first run of 592xp's came out? Because of the spike breaking that corner off. I...
-
No, this is the first service they've seen. The left noodly one is part number 597909701, the stiffer one on the right is part number...
-
I’d guess that the “wet noodle” had a fuel leak onto it that caused that. The old 028’s would leak fuel from the vent up onto the...
-
The same thing happened on the 385/390. Mufflers were rattling apart and Husqvarna had to make a MKII muffler for the 385/390. The...
-
I would agree with this, the last one I did was a little thicker
