ZERO's latest activity
-
Laminated? -
The sprocket nose bars were a similar design to the consumer bars of today. The sprocket teeth are quite different since the A-8 chain...
-
That oil channel inside the bar is wild. Is this bar tip sprocket much different than today's?
-
A lot of people know that I collect saws, I get several calls and messages every week about wonderful opportunities to buy things. The...
-
The carburetor needle slot is on the left side of the chainsaw above the fuel cap. The L and H needles are beside each other. The Lis...
-
OK, I’m going to show my inexperience. Where is the H carb needle? And do I turn it clockwise or counter clockwise? I’m using premixed...
-
Welcome! I would first try to adjust the carburetor. It sounds like the H carb needle needs turned out about 1/2 turn. Unless it’s one...
-
Hi, new member. My Echo CS 310 starts fine, idles fine, but when I hit the throttle it “bogs down” and dies if I don’t let off the...
-
Boxed up Jack’s pile o parts; boxed up the 066 flat top…heading to Wis; rebuilt 1 of 3 201s after watching Scott’s vid :p First one was...
-
-
Tennis 😉👍
-
Cool handle wraps
-
Thank you.
-
Nice family photo there!!
-
Last few years I've been hoarding 3 series spare parts all over European dealers and now it looks like moderately priced parts are...
