ZERO's latest activity
-
In theory, you could make a base piece that had a cutter mounted. You can definitely modify the cutter for other chamber contours. If... -
I did not make the squish cutter it is from dyno joe. The rings are interchangeable and can change what size cylinder you want to cut...
-
Yup, I have worked on many saws that looked like that, need to be an archeologist to dig the saw out of the dirt encasing it. Smart man!!
-
More photos of filth
-
A friend of mine texted me a photo of a ms290 he found cleaning out his parents house after they passed. I was gracious to have any saw...
-
nice finish. Does the outlet port not hit the brake when it's pushed down? I do mine similar but more to the front not at this time...
-
Husqvarna 572XP
-
Did you pickup any rpm or time in the cut?
-
finished today I had to modify the smaller pipe a little because at my first try the angle wasn't that good and therefor the...
-
I feel stupid for not catching that. I just worked on a QV 8000 that someone sent out from PA for me to put on a new rear handle/tank...
-
I believe I found the spot for that spring, not shown on the IPL but the only place I could come up with. Putting the saw back...
-
The ignition mark on the flywheel has to line up with the laminate edge of the coil leg just as the points open. As shown in the repair...
-
ZERO reacted to jacktheripper's post in the thread MCCULLOCH The official McCulloch thread with
Like.
But how did you know the timing was right?! 😅 -
I had the spark plug out of the head and grounded it while connected to the coil wire then spun the engine on the clutch side with my...
-
Well, my 850 isn’t much of the average 850 anymore nor yellow. But is finished other than adding the MC cover to the recoil spring