ZERO's latest activity
-
Husqvarna 572XP -
Did you pickup any rpm or time in the cut?
-
finished today I had to modify the smaller pipe a little because at my first try the angle wasn't that good and therefor the...
-
I feel stupid for not catching that. I just worked on a QV 8000 that someone sent out from PA for me to put on a new rear handle/tank...
-
I believe I found the spot for that spring, not shown on the IPL but the only place I could come up with. Putting the saw back...
-
The ignition mark on the flywheel has to line up with the laminate edge of the coil leg just as the points open. As shown in the repair...
-
ZERO reacted to jacktheripper's post in the thread MCCULLOCH The official McCulloch thread with
Like.
But how did you know the timing was right?! 😅 -
I had the spark plug out of the head and grounded it while connected to the coil wire then spun the engine on the clutch side with my...
-
Well, my 850 isn’t much of the average 850 anymore nor yellow. But is finished other than adding the MC cover to the recoil spring
-
ZERO reacted to jacktheripper's post in the thread MCCULLOCH The official McCulloch thread with Like.
The first time that I messed with a mini Mac, I wanted to make sure that the ignition was working right since I had just replaced the...
-
Yeah it was a bit tricky going back together but easier than I thought it would be. I rebuilt the auto oiler and today was the first run...
-
Getting the engine in and out of the case has been challenging for me on the MM6. I know you must pull the starter rope out a foot or...
-
Just finished the Mini Mac 6 ready to rip.
-
Just finished the Mini Mac 35 runs perfect.
-
Here’s my personal top handle.