ZERO's latest activity
-
ZERO reacted to Roschdworschd's post in the thread bigger carburetor for chinese chainsaw / Komatsu Zenoah clone with
Like.
The screws are glued in…it is not foreseen to open anymore. In normaly there should be no problems. -
ZERO reacted to legdelimber's post in the thread bigger carburetor for chinese chainsaw / Komatsu Zenoah clone with Like.
I think that I'd want to check the screws in that setup fairly regularly. Lots of pulse~vibration. But hey, the last bit of power always...
-
I would be afraid of it coming loose.
-
I would think if you are using a flat top piston, then probably not, if it is a pop-up then it might hit the booger.
-
I wouldn't be.
-
Should I be concerned with the little booger and the round marks in the top of my chamber?
-
Maybe you can tell me how to get a little old Poulan top handle saw to oil. It’s one of those with a screw-in check valve behind the...
-
I had to take the Jonsereds 520 SP all the way back down to correct a non-oiling issue, when I replaced the oil line out of the...
-
I somehow couldn’t see this sign and smashed the truck up pretty good.
-
The dawgs that @singinwoodwackr had made are very nice...
-
$2, never saw one before. I think a 10” duct cap will fit to get a bottom on it. I’ll probably use it for trash can in the house if I...
-
An internal leaking gasket will do such a thing, basically it's a short circuit of sorts.
-
Me either. If I can’t figure it out I’ll send it on its way.
-
Then I simply can’t see how the carburetor is the source of the leak.
-
I had the carburetor pressurized for about 10 minutes and it didn’t leak down. I set it down and started something else and didn’t...