ZERO's latest activity
-
Thanks fellers. Sorry too about derail...shirt happens -
Local hardware store sells an insert in there generic plastic divided bins, inserts are like 75 cents to a couple dollars depending on...
-
And welcome to keep going.
-
You're fine.
-
@Duane(Pa) I've had good luck with thin wall keenserts from McMaster Carr. Drill super slow and straight with lube on the initial cut. I...
-
EFSM. I smoothed out the sharp corners underneath the transfer caps and put a small bit of a "notch" in the transfer (4 port) most...
-
Yeah, I looked into timeserts, ended up going with a helicoil it off of Amazon for another job. They worked well for holding cylinder...
-
On some cylinders from Husqvarna(like the 390?), Helicoils were already installed from new. This should be fine if installed correctly...
-
Threads in jug at exhaust flange. I think it’s 5mm. Watched video of timesert brand. Tools are expensive inserts are reasonable…
-
Did you port the cylinder as well? Reason I’m asking is that I have already worked over a PB-580 and it really didn’t gain that well. It...
-
Should I admit to having put muffler screws on a hot stove element, before screwing them in? Yes pliers and a couple of room temp...
-
I hope there are some ducks flying in the morning, been a slow season so far out here in the mother land…
-
Nust have been one WHOPPER of a BELLY BUSTER.
-
No water left in the kiddie pool... not random.
-
Must have been closing time after drinking the bar dry? JS _
