ZERO's latest activity
-
Thanks! I should be able to give it a try this afternoon. The fact that it's oily from exhaust leaking out isn't going to matter? -
If you have any copper flashing/sheet, make a copper gasket and heat shield combo. I have never hade one leak yet . .
-
After a good run, retighten the two bolts on either side of the port holding the can on. No, that gasket will not fit, I recommend the...
-
I pulled the jug on my 362 to check some stuff and after putting it back together it was leaking around the muffler where it bolts to...
-
Send me a pm if your interested in moving it. I've been trying to locate a decent one for a while. Thanks
-
Finally was feeling well enough to machine a 7900 jug.
-
Well, tested after rebuilt carb actually runs worse, lol did something wrong. I didn't have a complete kit so cleaned things up, new...
-
Maybe...
-
For sale?
-
I know that some port other models to much higher rpm than the 242 originally has, originally I like a light 4 stroke, and now that I...
-
When Dozer Dan finished my 346xp (45cc) he sent a video of him noodling an oak round with it...at 18k, lol He didn't recommend I ran it...
-
They usually go up 10 lb after some use. Sometimes they'll get noticeably zippier just straightening out the curves and flattening...
-
Specs are 15.5K, personally I feel they tune nice on 15.2K, 4 stroke, and i kinda like to be a tad on the safe side.
-
Interesting. I thought they turned much higher, stock. At least that’s what the specs sheets I’ve seen show. Almost as high on the 246...
-
Specs show 15,5
