ZERO's latest activity
-
The one without a cover is not a McCulloch, probably a Skil. The newer one is a 610/650/Timber Bear derivative. There is one that is a... -
These are for sale local to me and not expensive, but I'm not terribly familiar with McCulloch. Anyone want to take a guess on model...
-
Nice haul!
-
I haven’t had any time to work on it. I’ve been sick since the weekend :(
-
Measured 4 of em, thinnest was 1.332, thickest 1.340, so the one I ground must have been for a 346.
-
How's the cylinder looking Greg... Curious how this one is going to run. If it runs half as good as my 346 it will be a nice build
-
Repair for someone? Same powerhead as the newest 08s which i believe was 61cc.
-
-
I do appreciate the UOAs that people post and there are some folks who seem quite well educated and informed. But it's important to...
-
That is putting it very, very mildly. Their level of OCD does not allow them to tolerate differing opinions. Granted, there are people...
-
y https://www.stihl.co.uk/en/ap/hp-ultra-two-stroke-engine-oil-1467 Edit starts here.... Below that it says FB
-
Hope that my answer would not be "the sum of all your fears"......since many BITOGers are a little bit on the OCD side regarding engine...
-
I use AI oil, it adjusts to the needs of my OPE. It conforms to all standards. For a 3-digit annual fee it can activate wireless...
-
I have a mix of stock and ported saws in the fleet, more oil isn't a bad thing.
-
Nothing wrong with that. Saber would probably be fine at 50:1. I just like extra oil even though it might not be necessary.
