ZERO's latest activity
-
Strike iron in flip-flops 😉👍 -
We had friends over that just left. Pretty well the one family that we get along with that isn't a hour away. Most kids around here are...
-
I have accumulated countless pro tips in my time as a metalworker. Here's one for the summer season...... avoid forging iron at the...
-
Which river is it?
-
The island is almost gone,, been about 4 hours,, and still raining pretty good
-
ZERO replied to the thread Husqvarna 564xp (g) fuel inject.Steve I too am waiting on the other side, a teardown/review or what will go wrong with these in the 1st year from a very trustworthy...
-
Those new tangled saws are all junk with low quality bearings dontcha know.... that and mtronic/autotune/ strato/ efi are epa sorcery!
-
Nicely and well put! Actual real life testimony based on facts and not just hear say!
-
There's been a lot of buzz going around about interest in the new 564XP saw with folks I talk to. Personally, I am excited to get inside...
-
Wow, I never knew about these steel pocket liners on the 620/590. With that freakishly long stroke, always wondered why the dmn things...
-
And probably why I never had an issue with the very early 562 I owned. There are guys that can eff up an anvil.
-
This must be why the guys I cut with and myself don't have the bearing problems. We are chain sharpening fools!, but honestly once you...
-
I have seen it on a Husqvarna concrete saw too, probably a K760 although that was years ago. Otherwise yes, only 372 XT. Seeing it only...
-
Bearings on the saw spin around and around... 🎶
-
Quote from your source- "Crankshaft flexing is what wears out the bearing pockets. The majority of the flex occurs in the crank pin...
