ZERO's latest activity
-
I personally would want to use a good new bearing with an aftermarket seal over a crunchy old oem bearing out of a part saw. If the... -
Good callout on the AM parts thing and the slip fit of the bearings on the crank.
-
This feels like a good time to bring up: using aftermarket parts in this bottom end setup can really shake up a build. I've never...
-
351 is basically a 353 with a 44mm top end. Open transfers. Magnesium case. If we're bringing up Jonsered, it would be a 2149
-
If it was mentioned I missed it. Does a 351 case fit into this equation?
-
In addition, PIB's used in two cycle oils are designed such that the "unzip" cleanly into combustible gasses once they reach a certain...
-
Yes, thank-you sir! I'm glad you could answer. Edit starts here. You are a "sir", right? lol
-
Thanks for your reply!
-
Its not used as a dispersent in two cycle oil. It is used as a clean burning low smoke base oil. And no, its not a viscosity improver...
-
Poly iso butene is used in almost all modern two cycle oils as a anti scuff additive. Its what replaced Brite stock in the old two...
-
grandpa would put bacon grease on the stumps he wanted rid of, come fall the bears would literaly eat the stumps.
-
That bacon grease belongs on toast--delicious!
-
With all the knowledge you could make jour own oils... or for beginning blend two or three types .
-
-
I was wonder about that, so I Googled a bit and found some info...
