ZERO's latest activity
-
Haha yup I deleted the video of it running but it was crazy the crank would shift every time you hit the gas -
Looks as if we were typing at the same time LOL.
-
@Shane¹ I too am looking for some clarification on your mod. Did you add another seal over the integral bearing/rubber coated cup with...
-
Yup I used a 6203 bearing shield on each side and it takes up the slack. When I built the first one I pushed the bearings out all the...
-
Sorry, I am not sure if I am picking up what you are putting down...did you make a spacer from an old oil seal to take up the slack...
-
This is what it looks like when the vent is missing. This is on a saw with a primer (I can’t remember if all the 350’s have primers)...
-
You can post up what you found. I do need to touch on tank vent modifications at some point in this thread for saws with the EPA vent...
-
How about tank vents falling off? I worked on several earlier this year where the white vent fitting wouldn’t stay in the tank and I...
-
I would like this thread to be useful to folks down the road. That being said, I think this is a great addition. I'm sure other folks...
-
If this clutters up Greg's build thread too much hopefully a mod can delete my post. But all of these builds are kinda his fault after I...
-
Oh, I have a small pile of those, I think only one left with the stock dished piston. A couple of them are now 346s. Some of these are...
-
There is definitely value in taking some time to modify the stock 350 for a low-buck rig. If you have run a good ported 346xp, you can...
-
Around seven years ago I did a 350 build with no timing changes. I got rid of restriction in the cylinder riser, smoothed all of the...
-
placeholder
-
placeholder
