High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

ZERO's latest activity

  • ZERO
    ZERO reacted to Jusgunn3's post in the thread Chain Sharpening with Like Like.
    I have before with my father in laws setup, worked pretty good I think. I have a grinder that I use though.
  • ZERO
    ZERO replied to the thread What oil is best? and what ratio?.
    Yes sir, this one burns really clean @ 32:1 compared to Castrol 2T racing. Will see how she will perform in the XS beauty once all snow...
    • 20251024_131309.jpg
  • ZERO
    ZERO reacted to EFSM's post in the thread treemonkey stuff with Like Like.
    Reducing the gap should technically advance the timing slightly but I don’t know if the smaller spark would be counterproductive.
  • ZERO
    ZERO reacted to Stump Shot's post in the thread treemonkey stuff with Like Like.
    Yes, as changing it will change the amount of voltage required to fire properly across the air gap.
  • ZERO
    ZERO reacted to cuinrearview's post in the thread nm with Like Like.
    With used junk, anything is possible. I just have never went into a new to me saw assuming something like that. If I got a saw under...
  • ZERO
    ZERO reacted to MR_T's post in the thread nm with Like Like.
    no worries
  • ZERO
    ZERO reacted to farminkarman's post in the thread nm with Like Like.
    Well, it looked to me like old carbon buildup with new scratch lines. Seemed like maybe a case of a good used piston + saw that had...
  • ZERO
    ZERO reacted to cuinrearview's post in the thread nm with Like Like.
    Now look what you've done:facepalm: I raffed
  • ZERO
    ZERO reacted to cuinrearview's post in the thread nm with Like Like.
    Valvoline Restore and Protect at 29:1 for three tanks="problem" solved.
  • ZERO
    ZERO reacted to dangerousatom's post in the thread nm with Like Like.
    What saw is it? an older saw with no side transfers will leave oil in the CC more then ones with them. . .
  • ZERO
    ZERO reacted to dangerousatom's post in the thread nm with Like Like.
    Id say crappy oil too, or running a very rich mix a few tanks and oil built up in the bottom of the CC. Then the saw was run near...
  • ZERO
    ZERO reacted to jacob j.'s post in the thread nm with Like Like.
    Naw - those look like pretty average wear marks to me. Most two-cycle pistons will pick up wear lines or marks. Apart from the burnt oil...
  • ZERO
    ZERO reacted to MR_T's post in the thread nm with Like Like.
    Yes, there is more buildup than I'm used to seeing. I'm not a big-time builder. I know how to take things apart and put them back...
  • ZERO
    ZERO reacted to huskihl's post in the thread nm with Like Like.
    It’s possible that it got hot but that usually doesn’t happen if the saw sounds right and is 4 stroking out of the cut (unless it has a...
  • ZERO
    ZERO reacted to hacskaroly's post in the thread nm with Like Like.
    That I don't know, I generally work on free or project saws and they usually come with issues. Looking at the carbon in the exhaust...
Show older items
Top