ZERO's latest activity
-
The pop-up pistons on eBay are mostly LRB or Farmertec and my experience with those is they're not a tight enough fit to the cylinder... -
My bad I have been looking it up just wanted to check with you pros on here for sure!!!! So it will work in the 2017 562 from what I...
-
I appreciate it, thanks!!
-
I guess it is my opinion.
-
Good to know, is this in general or in specific type/size saws?
-
Pop-ups can increase secondary compression, but they can also disrupt scavenging. I think they are unnecessary.
-
Are they not necessary because they create more/too much compression and increase wear on the saw or just unnecessary?
-
Oh I meant 46 mm….so that piston will work in this 2017 562??
-
The pre-mark II 562 ran a flat-top piston that is 46mm. There are some aftermarket pop-up pistons, but I wouldn't recommend them.
-
The OEM pistons used to be flat top but are now changed to a dished piston to reduce compression and hopefully lengthen engine life.
-
They do the 545, 550, 555, and 562. Here is the cost of new:
-
Not sure how much they run, but there are specific splitters for Husqvarna 5-series saws that have crank stuffers. The typical splitter...
-
How much do they run, and does it only split husky’s???
-
Hey guys would this 2017 take the 47mm piston??? Also I have heard they make a pop up or domed piston for the newer models do they...
-
Zama C1 carbs are flush with the top of body. Almost all Walbros are flush with metering chamber floor.
