ZERO's latest activity
-
Don’t worry, I’ll take it for you! -
One of these days I’ll tear mine down and figure out what’s wrong :p
-
I may have done similar to my 2100.
-
Piston and cylinder were fine. Crank was fine. I got lucky. Cases cleaned up, old bearings removed. Ready for reassembly tomorrow with...
-
Well it has become very obvious to me that I somehow sabotaged my own saw. As soon as I started tearing it down, I removed the air...
-
I want to use my 266xp again, so it’s time to tear this thing down and do the bearings
-
ZERO reacted to hacskaroly's post in the thread 2025 Christmas Giveaway Saw MS390 - Boedy @ Empire Builders (Closed) with
Like.
Awesome, thanks!! -
ZERO reacted to jacob j.'s post in the thread 2025 Christmas Giveaway Saw MS390 - Boedy @ Empire Builders (Closed) with Like.
I'm gonna move this to the Chainsaws section where it will get more views.
-
ZERO reacted to hacskaroly's post in the thread 2025 Christmas Giveaway Saw MS390 - Boedy @ Empire Builders (Closed) with Like.
For those who have not seen this yet, Boedy at Empire Builders is doing a 2025 Christmas giveaway saw, a MS290 converted to a MS390...
-
Hauled my buncher out to the timber claim Been pretty nice weather so far. Going to get colder next week
-
ZERO replied to the thread Mikes chainvises.Mike hope you too are doing well. We are busy with them squares. All the best your way.
-
-
I have a Mac 10-10 that ate its ring and punched the bits into the squish band on its last few rotations - I will need to get someone...
-
An autodecomp crumbled to bits on my 555 and dropped down into the cyl. Piston pushed the bits up into the squish band, some big dents...
-
Have for sale a ported flat top 066 by Krafterized Work & Performance Saws LLC. Saw has a new oem piston,rings,seals,impulse,fuel...
-
As for size and type, I tend to run 67-76cc saws with 24” bars and full wraps as a standard for firewood. Most of my firewooding...
