ZERO's latest activity
-
ZERO reacted to Sloughfoot's post in the thread Preparing to port first saw - which one, and what method? with
Like.
Had to reread it a time or 5, myself. I believe what he's getting at is a higher blowdown number (lower transfer roof) won't cut at as... -
ZERO reacted to jacktheripper's post in the thread Preparing to port first saw - which one, and what method? with Like.
This seems contradictory to this: What do you mean @huskihl? Thanks for your replies!
-
ZERO reacted to huskihl's post in the thread Preparing to port first saw - which one, and what method? with Like.
A couple more degrees of blow down usually makes it a little bit more forgiving, but won’t hold RPMs as well in a simple down cut. You...
-
ZERO reacted to jacktheripper's post in the thread Preparing to port first saw - which one, and what method? with Like.
Didn’t measure compression, but it definitely feels stronger. I put a ring in it less than a year ago, and it honestly hasn’t been run...
-
ZERO reacted to Sloughfoot's post in the thread Preparing to port first saw - which one, and what method? with Like.
Yeh, No expert but I'd think the shorter stroke would call for less blowdown. I believe popular opinion for an 044 is 20 blowdown...
-
ZERO reacted to jacktheripper's post in the thread Preparing to port first saw - which one, and what method? with Like.
044 is 50mmx36mm 272 is 52mmx34mm I wonder how the bore/stroke ratio comes into play with blowdown. My 266xp that I ported without...
-
ZERO reacted to Sloughfoot's post in the thread Preparing to port first saw - which one, and what method? with Like.
Iirc 102 22 78 is what he's said his target numbers are for 044s.
-
ZERO reacted to jacktheripper's post in the thread Preparing to port first saw - which one, and what method? with Like.
Mastermind was at least two seconds faster in the same wood. MOFO 440 hybrid was almost four seconds faster.
-
ZERO reacted to Sloughfoot's post in the thread Preparing to port first saw - which one, and what method? with Like.
How's it compare to your Mastermind 044?
-
ZERO reacted to jacktheripper's post in the thread Preparing to port first saw - which one, and what method? with Like.
I think it should bring some more torque in the cut. Any thoughts @Stump Shot @huskihl ?
-
ZERO reacted to Sloughfoot's post in the thread Preparing to port first saw - which one, and what method? with Like.
What's the tradeoff with lower blowdown? Peaky torque curve?
-
ZERO reacted to jacktheripper's post in the thread Preparing to port first saw - which one, and what method? with Like.
Here’s what I did: Here’s the video: 272xp mod #2 Seems to have shaved 2.5 seconds off. I am contemplating raising the uppers more...
-
ZERO reacted to huskihl's post in the thread Preparing to port first saw - which one, and what method? with Like.
Run it without the air filter and see if it gets better. It could be plugged up, but I doubt it’s the actual air filter design. Only one...
-
ZERO reacted to MemphisMechanic's post in the thread Preparing to port first saw - which one, and what method? with Like.
let is know how it turned out, once you run it! I second this reocmmendation. I have redbeard’s foam filter & velocity stack on my...
-
Blue mix is best mix.