ZERO's latest activity
-
Not buying thus one make me feel like an actual responsible adult. I already have a beautiful 359 that I didn't need in the first... -
I feel very targeted, worse than the adds on facebook!
-
ZERO reacted to SawAddictedFarmer's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with
Like.
A 462 that went by Randy's place. I'll try to get pictures and see how they cut tomorrow. Just figured I'd try no top plate angle on... -
ZERO reacted to KS Plainsman's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
What saw is that chain on? Or, do you run those measurements on all chains for all sized saws?
-
ZERO reacted to SawAddictedFarmer's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I did some 33rs and Oregon at 30/55/0. I'll try and get pictures up tomorrow and see what you all think could use improvement.
-
Thanks for your response - I believe I have an understanding of the concept - look forward to the in-the-cut video
-
Don't hold back, that plating is tough stuff. Great first rebuild candidate you have there.
-
Keep going. Have to to remove ALL of the transfer. You're gonna be at it a while with 500 grit. After it's gone hit the bore with red...
-
Keep sanding if the spot gets bigger it's junk if it cleans up more might be ok
-
That’s definitely aluminum. Either transfer still on the plating or no plating.
-
-
So I hit it with some 500 grit, I can definitely feel a low spot with my fingers here below, and also above, the exhaust port. Not sure...
-
Thanks, head is still spinning a bit.
-
Kit the carb, use a 372 intake clamp. New fuel line. Clean up the stock jug and get a meteor piston. I had a quad port 45mm hyway jug...
-
Congrats on the babies! It's always hard to tell from photos, but you might be able to salvage that cylinder. With a saw that old, a...