High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

ZERO's latest activity

  • ZERO
    ZERO reacted to jacktheripper's post in the thread What's on your bench? with Like Like.
    Yeah, when I got it I decided not to split the cases, but it was evident that it had high hours on it.
  • ZERO
    ZERO reacted to Partner's post in the thread What's on your bench? with Like Like.
    The looseness doesn't bother me, the leakage does 😎👍
  • ZERO
    ZERO reacted to EFSM's post in the thread What's on your bench? with Like Like.
    Does the saw have a lot of hours on it? Many saws use C3 tolerance bearings, which have a little play from new.
  • ZERO
    ZERO reacted to jacktheripper's post in the thread What's on your bench? with Like Like.
    Just so happened to check the crank for play on my 266xp. Slight radial play. Time for bearings.
  • ZERO
    ZERO reacted to bwalker's post in the thread Oil questions... with Like Like.
    Same applies to them if that's the case.
  • ZERO
    ZERO reacted to Fabulous's post in the thread Oil questions... with Like Like.
    I’m 99.9% certain Husqvarna uses a similar 200hr continuous wide-open throttle test on their chainsaws (55 minute on 5 minutes idle) …...
  • ZERO
    ZERO reacted to bwalker's post in the thread Oil questions... with Like Like.
    Its very fishy for the reasons I pointed out.
  • ZERO
    ZERO reacted to bwalker's post in the thread Oil questions... with Like Like.
    An example of 1 is statistically meaningless. The most important alide is the one showing the valves. Notice that all the air cooled...
  • ZERO
    ZERO reacted to EFSM's post in the thread Oil questions... with Like Like.
    That test looks fishy. I’ve seen buildup in engines like that only once or twice, and that was on high hour trimmers getting run without...
  • ZERO
    ZERO reacted to bwalker's post in the thread Oil questions... with Like Like.
    See the edit to my post. I am certain that the rough finish doesn't hurt a thing and neither does a mirror finish. This is based on the...
  • ZERO
    ZERO reacted to EFSM's post in the thread Oil questions... with Like Like.
    Ditto. I think a clean exhaust port that doesn’t build up carbon easily is more valuable than a slightly rough one that might.
  • ZERO
    ZERO reacted to Fabulous's post in the thread Oil questions... with Like Like.
    Check out slide 11 - the results will surprise you. I cannot find the msds sheets for motomix - must be a “secret proprietary...
  • ZERO
    ZERO reacted to edisto's post in the thread Oil questions... with Like Like.
    That was my thinking too, but now I'm curious about how a rougher finish on the exhaust port might affect carbon deposition. I'll add...
  • ZERO
    ZERO reacted to Fabulous's post in the thread Oil questions... with Like Like.
    https://www.slideserve.com/delano/stihl-inc-mix-oil-comparison
  • ZERO
    ZERO reacted to bwalker's post in the thread Oil questions... with Like Like.
    Most oils that combust cleanly with sharp tuning dont have much smell. Castor oil has that sweet racy smell because its not completely...
Show older items
Top