ZERO's latest activity
-
This is the problem with examples of one. Time will tell. -
I agree on the looks, neither come with screws so doubt I will try one.
-
Video states mm and timing advanced, minimum required mods for any saw. They should all be ported..
-
Think they’re all broken in and by sounds of the saws they’re not stock
-
Same here. I don't think there's quite as much left on the table on these newer saws. Not saying they can't be improved though... Gotta...
-
Wonder if his 400.1 is broken in vs the 400. On the dyno, the 400.1 looked better. Looking forward to see Joe’s results on the ported 400.1
-
I guess one way to check is after running it wide open and then shutting it down, pop the fuel cap (release any pressure) and then...
-
Yeah, I have been thinking about the mixture. The saw runs great at wide open throttle. Do you think I should just richen the low end...
-
The 5020 is usually a good cheap saw like the 2000 series was. Buy yourself a Briggs & Stratton inline spark tester, its like 25 bux on...
-
My Echo’s start better than my Stihl and Husqvarna. Maybe give it echo in look and save some coins.
-
I use regular unleaded at 40:1. Any 2 stroke oil I have on hand.
-
I wish I had more info for ya. I just cut firewood at my Northern Michigan property....nothing crazy. When I shut the saw off to rest...
-
Yeah, I figured a new saw just out of the box would be tuned and ready to go.....apparently not! 🤣
-
Welcome to the forum! Do you have any further information you can add, such as fuel type used and how long it takes to cool down before...
-
I have one too. Every time I would start it I would have to retune the carb to keep it running. Now it wont start at all. Probably...
