ZERO's latest activity
-
I store my saws with topped off fluids & ground chains so that they are ready for the zombie apocalypse. ;) -
even though i have fixed some of them. i usually dump them so i dont have a big mess
-
Mine sit on oak boards, some are soaked dripping oil, others are nearly bone dry - depending what saw sits on them. I considered...
-
ZERO reacted to Junk Meister's post in the thread Modifying an AM MS381 Cylinder to fit on a Stihl 440. with
Like.
Do They make UPSIDE DOWN CASE SAVERS? Like in the VW 1600cc Dual port to the ?2180? -
ZERO reacted to lehman live edge slab's post in the thread Modifying an AM MS381 Cylinder to fit on a Stihl 440. with Like.
Could honestly see that thickness plus a poor cast in combination being an issue but may I’m wrong
-
ZERO reacted to Rich Fife's post in the thread Modifying an AM MS381 Cylinder to fit on a Stihl 440. with Like.
Imnot a fan of 100:1... then again, im used to 40-50:1. I know guys that run 100:1 without any issues. 🤷♂️
-
ZERO reacted to Rich Fife's post in the thread Modifying an AM MS381 Cylinder to fit on a Stihl 440. with Like.
Approximately .300". I can measure later.
-
ZERO reacted to EFSM's post in the thread Modifying an AM MS381 Cylinder to fit on a Stihl 440. with Like.
bad idea. I refuse to believe that oil is twice as good as anything else.
-
ZERO reacted to lehman live edge slab's post in the thread Modifying an AM MS381 Cylinder to fit on a Stihl 440. with Like.
H How thin was the base after machine work was it just crap pot metal or that thin causing the two ears snapping off. Or piston got hot...
-
ZERO reacted to Rich Fife's post in the thread Modifying an AM MS381 Cylinder to fit on a Stihl 440. with Like.
Yeah, Juuuust a bit over the top. Lol. He said it was his favorite saw until it stopped running. Lol I picked it up, pulled the rope...
-
ZERO reacted to Rich Fife's post in the thread Modifying an AM MS381 Cylinder to fit on a Stihl 440. with Like.
Yes... CHINA
-
It's better if you pull the plug and do it upside down. blow it out.
-
they say, they sell it next year in a very limited amount. so i think, it's very hard to get one.
-
That’s how I see it. Probably be a limited number or one year only run.
-
Metric and imperial are equally common here. I usually use imperial on stuff I build. Most older equipment is imperial. Automotive and...