ZERO's latest activity
-
ZERO reacted to Catfishclark89's post in the thread Looking at upgrading and would welcome advice/opinions. with
Like.
Yeah I’d go for a 362c, 400, 562c, or even the previously mentioned echo 620p. Those saws would do fine with a 20-24” b&c in cedar. -
ZERO reacted to dthieme's post in the thread Looking at upgrading and would welcome advice/opinions. with Like.
I personally would consider the next size up saw if it's in your budget. The 261 is a great saw, but if you are cutting anything of...
-
ZERO reacted to hacskaroly's post in the thread Looking at upgrading and would welcome advice/opinions. with Like.
The 261 is a great saw with its power to weight ratio. Carb vs. C-M ends up being personal preference, if you like to adjust carbs (or...
-
ZERO reacted to old saw fixer's post in the thread Looking at upgrading and would welcome advice/opinions. with Like.
I use Stihl and Echo power equipment, but lately have bought Echo. I have a Stihl 261CM and would recommend it to you. The Mtronic...
-
ZERO reacted to IffykidMn's post in the thread Looking at upgrading and would welcome advice/opinions. with Like.
Have several standard carb 261s run a 16" B&C and have no complaints for a 50cc saw, I tend to run short for cc bar and chains. Good...
-
ZERO reacted to Stihlalltheway's post in the thread Looking at upgrading and would welcome advice/opinions. with Like.
Elastostart is very different from the easy start, just a stretchy rubber part on the pull cord that makes life a little better...
-
ZERO reacted to tallgrass_coyote's post in the thread Looking at upgrading and would welcome advice/opinions. with Like.
Had a seasonal job after college working for the state wildlife agency. Main job was to kill trees (girdle+tordon). My boss bought a...
-
A while ago I bought this 261 arctic from Bill and sent it over to 309 for a wrap and for port work. After tinking with the stock wrap I...
-
What was under my Lull Zoom on the cyl scratches
-
Roll cage going in the race car - '72 Javelin for the 24 Hours of Lemons.
-
Thats pretty cool.
-
I contacted the seller & he said there's no blue to the conn rod,the keyway slot looks good,& the bearings have "normal slop".I'm not...
-
Hi Ed, I wouldn't do a piston swap either... I would remove 2 rod bolts and needle bearings and swap the rod and piston from your saw...
-
I took a look at this crank & piston,& the piston is pretty well shot - it's got some deep scoring to it.You might say "change the...
-
ZERO reacted to Scott Kelsey's post in the thread MCCULLOCH The official McCulloch thread with Like.
Mark, thank you very much. This is extremely helpful. I will read your link this evening.