ZERO's latest activity
-
I find that if you run the saw empty, refuel and then restart, if the saw is still hot/warm then using the choke will result in the saw... -
I left the choke lever out on my first attempt, after refueling. I figured the saw was starved for fuel because I continued pulling with...
-
Glad you like your saw. Did you accidentally leave the choke lever out? If not, the only other way fuel gets through the system is...
-
XS372xp, recently acquired, great saw. 5 tanks through, runs and cuts great. I'm cleaning up a dead fall, working until dark. Put...
-
I didn't find the short block for the 10-10 today,but I have a couple other places to look.The crank on feebay (according to the seller)...
-
Mark,according to the IPLs I have,the PM10-10 & the PM55 take the same crankshaft,part # 87699 for both.I've got a 10-10 short block...
-
Ed - your PM55 has points ignition, make sure any crankshaft you get has the points cam/lobe. All of the 54, 57, 60, and 71cc 10 Series...
-
Scott, I would normally start with 1-1/14 turns open on both H &L. The fact that it starts with throttle and no choke would indicate...
-
I've got a PM55 that had an accident back in April.The saw fell off a shelf & broke the rear handle off.I swapped out the tank handle...
-
Seems to me you got it running ok Scott?
-
ZERO reacted to Scott Kelsey's post in the thread MCCULLOCH The official McCulloch thread with
Like.
-
ZERO reacted to Scott Kelsey's post in the thread MCCULLOCH The official McCulloch thread with Like.
Hoping someone here will help me out as I did some searching, but can not find what I am looking for. I recently purchased this Pro Mac...
-
ZERO replied to the thread 400.1 first impression.Richard Flagg has some nice videos on them mixing ratios and film strenght on them engine parts.
-
I have one and I love that saw! GLWS
-
Very nice! Great firewood saw. Actually just a great saw. I already miss the couple I sold.