ZERO's latest activity
-
His prices are good. He's down to $25 per 20" loop or $27 per loop after shipping, if you order a few at a time. I wondered if he'll... -
Sold out.
-
Appreciate you doing this.
-
It's like comparing 3/8 and 404 on durability, same thing basically. I cut some old rock hard yard trees. RSP isn't too good on that...
-
Wouldn’t doubt you may have a mix of .063 and .050 narrow kerf for different stuff
-
You got it.
-
I like em too. Got my first versacut bar in 2020, have since gone through a half dozen .325 20 inch versacut bars with oregon lgx .325...
-
I’m sure the smaller narrower tooth won’t take as much abuse and I could see it binding easier on wet/stringy wood that’s larger...
-
50 gauge NK cuts faster...obviously. But there's things about it I don't like.
-
I have a few loops of 16" .063 left that I will use up on the 026. But setting up my "new" 261 I would prefer the longer bar and with...
-
FWIW, I have been using Stihl 23 RS Pro (supposedly NK?) on "regular" bars with no ill effects. I don't have any nub chains, so I'm not...
-
Here’s another from today. 254 vs 372. I’d say that 254 pulls pretty hard! I used it for about three hours today and I love it!
-
this is a better photo of the plane
-
today we went for a ride in this 1929 bi-plane
-
Dual ported the 394xp muffler today. I also opened the factory outlet wayyyy up Should do good for blowing off chips while milling...
