ZERO's latest activity
-
I put it on ribs so they'll be kosher. -
While back I hit a deal on a 461 from David newbie on AS. Just got it from Kevin. My first one is ported for grunt, this one for speed...
-
-
Chain too big 😉👍
-
Time to do the 394 cases. Look at that chain rash… I’ll probably drill the end of the crack and smear some JB weld on it.
-
The 254 runs! Still waiting on some parts though: clutch cover, bar plate, tensioner, switch block off plate, screws, and choke lever...
-
I have not investigated the Porter Cable saw very much so I am not sure who built the engine. The styling of the cylinder and fits is...
-
ZERO reacted to Mad Professor's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
New P/C clearance should be ~0.002" on a small saw. Long ago I was doing a bunch of 038 ----> 038M conversions and had access to good... -
ZERO reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Nothing in the repair manuals for measuring ect even the technical data sheets that I have. How clean was the exhaust screen on the saw...
-
I don't think there will be anything more than the standard cylinder/piston diameter of 37 mm and ring thickness of 1.2 mm. If the...
-
ZERO reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
I don’t know for sure if my 170-180 repair manuals say but I will look this afternoon and let you know if it says.
-
Chris - do you know what the cylinder and piston measurements should be? I don't mind putting a piston in it, but I'd like to know the...
-
ZERO reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Sounds like new rings bearings and seals will do it maybe a piston
-
I went ahead and tore the 170 apart, piston and cylinder look fine but compression is only 105 PSI. Mark
-
That is a rough forging, Mark