ZERO's latest activity
-
I checked it with my tach today, and she is doing around 3000 at idle and 12600 WOT. So, I guess I am in good shape. The 194 manual says... -
The exact idle speed is not that important. According to manufacturers, the most common tolerance for its setting is ±200 rpm, which...
-
I have also found that when the chain is too tight it can stall the saw when you release the trigger. It's as if the extra tension can...
-
Thanks. According to my manual, it gives the idle speed after factory carburetor adjustment of the hi/lo screws as 3000 rpm but it...
-
An overheated clutch spring causes the clutch to engage earlier
-
Officially, the idle speed for MS 194 is 3000 rpm. I think it is unlikely that enriching the idle mixture with the L screw helps in...
-
Matter of fact, I encountered this very problem on my new to me MS-194C yesterday. It would die out after a long cut. I richened the low...
-
ZERO reacted to Sawponder's post in the thread SELLING *Reduced* Sachs dolmar 116si & 120si with
Like.
120si -
ZERO reacted to Sawponder's post in the thread SELLING *Reduced* Sachs dolmar 116si & 120si with Like.
120si
-
ZERO reacted to Sawponder's post in the thread SELLING *Reduced* Sachs dolmar 116si & 120si with Like.
Additional 116si pictures
-
ZERO reacted to Sawponder's post in the thread SELLING *Reduced* Sachs dolmar 116si & 120si with Like.
*will consider parting out, if you have any parts request, do let me know* Im posting these saws in one post because they are...
-
She'll fit right in with other red headed German girls
-
Awwww, I wanted her! :rolleyes:
-
Send me a message and we will get the details all ironed out
-
Thank you...that was a close one !!! 😂 Ernie