ZERO's latest activity
-
Made my own.Works well. -
Haven't had any luck with one, but I haven't tried really hard.
-
Do the roller bearing style rail closers work? I have a few .058’s that I would like to take down to .050 They might be clapped out...
-
ZERO reacted to lehman live edge slab's post in the thread Husqvarna 564xp (g) fuel inject with
Like.
Don’t think anything will go that far but I just don’t think anyone will find it worth the time to make a repair scanner not a... -
I don't think you need the gas tank but I can try swapping my handles if you would like to confirm
-
local, former jonsered dealer said to put the 562 stuff on. I would need the gas tank, top handle also, because of the angles involved.
-
Also interested.
-
I finally bought the Stihl brake spring tool after fighting with them for close to twenty years.
-
Nothing like putting these saws back in action after they've been thrashed.
-
My mk1 550 I bought new is a miserable pos to start cold but doesn’t have any of the normal problems. I had one I bought used and it was...
-
Looks good Jack!
-
I also got my new Alaskan mill put together. 30 inch rails, but I also have 48 inchers too. Looking for a big ass bar for the 48’s...
-
Finally seem to have gotten my 372xp figured out. Ran like it had an air leak, so I replaced crank seals and clutch side o-ring. But I...
-
Pop off at 13 to 14 psi
-
Makes sense. Pop pressure i am not sure. I can test it later. For reference, on my mildly ported cs400 my settings are 3t out on high...