ZERO's latest activity
-
Yeah, you get into a groove taking it apart with one tool and then they switch it up on you, in the end it takes 3-4 tools to get them... -
All of them were snug on this old saw and it doesn't look like it had ever been apart. I did see what looked like blue loctite on two...
-
No doubt. Mine are built within a couple years of each other and the 2100 isn't much different than saws 20-30 years newer and this...
-
McCulloch made a lot of their own fasteners so if someone decided a 10-24x11/16" slotted hex head screw was needed, they gave it a part...
-
Bump need more shelf space. Send me an offer. Possible trade for project saws
-
Crap. I just realized that I forgot to insult you for being too lazy to pick up screwdriver and adjust carburetor. I must be slipping...
-
Some of the .050 stuff is getting particularly less robust on the complete assembly, needless to say stretching is a bad issue with that...
-
I run 3/8 .063 on everything from 16-36" bars on 50cc saws and up. Some smaller saws get smaller gauge chain; the 3120 gets .404 .063.
-
FWIW the 48" hard nose bar on my avatar saw is .404 by .058 .I'd imagine though it's 40 years old or older . Fact I bought one of the...
-
Does the saw run for a few seconds if you put some mix through the carb bore? Did you reverse the intake block gaskets? The impulse...
-
He tends to miss the finer things in life such as the girls on horseback at Tractor Supply.......blew that one.🤔
-
Wrong one for a ms 441 though, need a green all 441’s were mtronic version 1 and the green is the replacement for a black one.
-
This arrived from Amazon. Similar to a mod I did, with spray paint and a length of boot lace, several years back, but factory made, with...
-
I like both versions, however I can see that welded eyelet getting in the way on some saws. Mabe worth trying to weld that eyelet on...
-
It always comes back to the shaft with you doesn’t it Sean!😘
