Yellowking86's latest activity
-
Yellowking86 reacted to jacob j.'s post in the thread HELP! Identifying some old equipment with
Like.
Can you get better pictures? Those pictures are so small that none of the labels can be made out. I see two pieces that might be... -
-
-
A friend of a friend is selling some old equipment that was his grandfathers. It looks like a couple of them are chaingrinders, has...
-
-
Yellowking86 replied to the thread SOLD Ported 500i R.Interested in any trades? I have a couple 90cc ported saws. 9010 ported by stump shot and 592 ported by XS
-
The only way I know of to check the pump valves is to put a vacuum on the inlet with the metering needle removed.
-
Yellowking86 reacted to Stump Shot's post in the thread HELP! 572 idles bad and won’t rev up with Like.
Correct on the place for pressure testing. Even 7 PSI is plenty for leak testing, I haven't found it necessary to check for pop off...
-
Yellowking86 reacted to huskihl's post in the thread HELP! 572 idles bad and won’t rev up with Like.
Make sure you’re checking on the right port. The one on the bottom right of the carburetor is the fuel supply for pressure testing. EFSM...
-
The metering chamber should not have pressure in it when testing. If it does, then the needle is leaking. Make sure you have the tester...
-
Yellowking86 replied to the thread HELP! 572 idles bad and won’t rev up.the carb won’t hold pressure, sounds like it’s coming from the nozzle?
-
Yellowking86 reacted to srcarr52's post in the thread HELP! 572 idles bad and won’t rev up with Like.
It's an Autotune saw, there are no H&L screws.
-
Waking up from a long winter's nap and hoping to move some older stuff out to make room for new inventory. use discount code...
-
Yellowking86 replied to the thread HELP! 572 idles bad and won’t rev up.I did not, I will check those out thank you
-
Yellowking86 replied to the thread HELP! 572 idles bad and won’t rev up.Bearings seem fine, I cleaned the carb and out a new diaphragm in it. I checked to e flywheel for a sheered key. Maybe it’s the...
-
Yellowking86 reacted to Poleman's post in the thread HELP! 572 idles bad and won’t rev up with Like.
I would check and clean the carb first. If it’s a used saw the inner screen is probably dirty. I’ve see a lot of fines getting through...
