Woodslasher's latest activity
-
-
My fault. It was in a PM, not a thread.
-
I'd put it back together and give it a good whack on either end with a brass hammer. Reinstall the flywheel nut flush with the end of...
-
For what it’s worth, I own 3 562’s and only one 500. I just call it like I see it
-
Do you have a good-sized brass hammer that you can give it a good whack with? Using a punch and a hammer, you're likely not getting...
-
Woodslasher reacted to redline4's post in the thread Not so pros 4 new and without politics or drama with
Like.
I'll give it another coat when it warms up this spring. -
Woodslasher reacted to beaglebriar's post in the thread Not so pros 4 new and without politics or drama with Like.
Afternoon boys. Welded up a cart for the log winch. Been wanting to do this for a while. Nothing special, needs paint but it will make...
-
Woodslasher reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics or drama with Like.
Morena E Hoas.
-
Woodslasher reacted to jacob j.'s post in the thread Not so pros 4 new and without politics or drama with Like.
Happy Birthday @huskihl :flamethrower2:
-
Woodslasher reacted to oddsaws's post in the thread Not so pros 4 new and without politics or drama with
Haha.
Get ‘after’ pics when you bump into them at the baggage claim on your arrival home 😄 -
I straightened a 7900 one after pressing in a new bearing and then welded the pin as well. Actually done it 3 times now none have...
-
Plow disc re-uses? I used a notched edge one for a (short) fan base. I had acquired some serious blowing, 2 ft diam, gable fans. A...
-
A friend of mine who owns a body shop gave me this can. I did two coats earlier today. We’ll see how this old stuff does. It was...
-
$25 for 8 ounces of POR is not less expensive than $40 for a quart of Red Kote. I have used POR15 in the past and will say that in my...
-
I often pre buy a replacement of what I'm very likely about to ruin. So far my extra cylinder to ruined cylinder ratio is 2:1.