Woodslasher's latest activity
-
Chinese Olympics by Anna Bolic. -
Roosters Mistake by Rhoda Duck.
-
Hole in the Mattress by Mister Completely. :cool:
-
I am and just did!
-
It’s a preheating kit, so the intake can pull some of that warmer air off the cylinder.
-
Mag II is back in business. New Dukes piston and OEM rings. Also, needed a new oil pump and spur gear and a couple other smalls.
-
Today I installed my last two parts for a Husky 365 that I bought from @redneckhillbilly (great guy to buy from!!). This was a fun...
-
Parts for this cream sickle showed up so got the bottom end together and started putting it back together
-
I replaced the throttle assembly with a nos after noticing the thing was not quite getting to full throttle. Got a few hundred more rpms...
-
In theory, you could make a base piece that had a cutter mounted. You can definitely modify the cutter for other chamber contours. If...
-
I did not make the squish cutter it is from dyno joe. The rings are interchangeable and can change what size cylinder you want to cut...
-
Main issue i get is these older saws need a muffler or something you might as well do all the gaskets around the cylinder. hard to not...
-
Made a stand for my squish cutter so I didn't need to use the vice in my work van. Then got squish band cut for 7900 with solo crank.
-
It was helpful to have four saws to pull parts from. And it was far from clean to begin with! I used to hate these saws, but building...
-
It’s actually carbon from the muffler and it bothers me greatly lol.
