Woodslasher's latest activity
-
I was drilling out a waterpump bolt on a Chevy in my 20s and had hair down to my belt , the drill grabbed my hair so quick I thought... -
I met a guy that got himself wrapped up and yanked on so hard by a large angle grinder that it jacked his back up, put him on permanent...
-
Angle grinder,,, you smell the damage before you feel it,,,,trust me,,
-
Yeh, those angle grinders will give you a heavy case of 3rd degree rash real quick. My Dad had a wire wheel throw a wire up his nose...
-
Lathe accidents? Been thirty odd years. A guy had a conveyor roller shaft set up in a lathe. The shaft was too big to fit inside the...
-
You have to watch a few videos on YT "Idiots in work" 😉 👍 you can avoid a few mistakes this way 😎 I watch it myself 🤠
-
Maybe, lucky guess, I swear. You can't prove it. ha ha. I twisted an angle grinder up in my sweatshirt 20 years ago too. Loose...
-
Shirt. Sounds like you have experience with this
-
You jam it in a port or twist it up in your shirt.
-
This feels like a good time to bring up: using aftermarket parts in this bottom end setup can really shake up a build. I've never...
-
This is what it looks like when the vent is missing. This is on a saw with a primer (I can’t remember if all the 350’s have primers)...
-
If this clutters up Greg's build thread too much hopefully a mod can delete my post. But all of these builds are kinda his fault after I...
-
Around seven years ago I did a 350 build with no timing changes. I got rid of restriction in the cylinder riser, smoothed all of the...
-
There are many different ways to do a muffler mod on these and results may vary depending on what other modifications you do along with...
-
The last big problem area for these saws is the mufflers rattling themselves loose. On some saws this led to exhaust gases burning a...
