Woodslasher's latest activity
-
Maybe, lucky guess, I swear. You can't prove it. ha ha. I twisted an angle grinder up in my sweatshirt 20 years ago too. Loose... -
Shirt. Sounds like you have experience with this
-
You jam it in a port or twist it up in your shirt.
-
This feels like a good time to bring up: using aftermarket parts in this bottom end setup can really shake up a build. I've never...
-
This is what it looks like when the vent is missing. This is on a saw with a primer (I can’t remember if all the 350’s have primers)...
-
If this clutters up Greg's build thread too much hopefully a mod can delete my post. But all of these builds are kinda his fault after I...
-
Around seven years ago I did a 350 build with no timing changes. I got rid of restriction in the cylinder riser, smoothed all of the...
-
There are many different ways to do a muffler mod on these and results may vary depending on what other modifications you do along with...
-
The last big problem area for these saws is the mufflers rattling themselves loose. On some saws this led to exhaust gases burning a...
-
The next problem spot I want to address (only applies to saws with the cylinder riser) is the cylinder riser. On every single 350 I...
-
The first problem area on these saws that I want to cover is the intake boot clamp. Husky for some reason decided to use an integral...
-
I had to get the only one I’ve seen with a full wrap handle.
-
Woodslasher reacted to Yukon Stihl's post in the thread Random pics (that you took) thread... with
Like.
What are you going to do when it gets cold? We just finished a week of 40 to 55 below F My boiler was running wide open for 11 hours out... -
Woodslasher reacted to lilspenny's post in the thread Random pics (that you took) thread... with Like.
Covid, 2021@ Lowe's in Madison, AL
-